TM sig p226 rail problem.

[Damned]

ok, so, i have a TM p226 which ALEGEDLY has a 20mm mount. however, i also have a king arms laser and mount which is also 20mm, and the mount clamps the pistol frame closed and the slide jams on the way forwards.

i also have the same problem with my glock 23. !

now, am i tightening it too much? are there any other cases of this happening and whats my best course of action to remedy the situation?

ive tried using a dremmel to widen the mount, but again when tight enough to not fall off the mount clamps the frame close

[Styrak]

Buy a metal P226. :P

[Damned]

Originally Posted by Styrak

But a metal P226. :P

[dodger_me]

or get a different laser

[DarkAngel]

My 20mm G&P Scorpion fits on it, as well as the star QD6.
Both fit perfectly with no flaw and no interference with the slide.

[CalvinTat]

When I had my Streamlight TLR-2 I had no problems with the frame that you describe, although I have since sold the TLR-2 and have upgraded to a full metal P226.
Honestly, a cheap Full Metal kit (Guarder) is only around $150CDN when ACA had them, but some frames and slides can get upwards of $500. Talk to Illusion and see what he can do for you, cause nothing is better than the feeling of cold metal in your hands.

[dodger_me]

i was just on airsoftpart.ca and they have some for one fitty dorra

[Styrak]

Originally Posted by CalvinTat

Talk to Illusion and see what he can do for you, cause nothing is better than the feeling of cold metal in your hands.

And nothing sounds better.