Airsoft Canada - View Single Post - problem : Hi capa with upgraded slide and frame

ichimaru gin · November 7th, 2008, 07:14

Guys, I just installed shooters design metal slide and frame into my hi capa 5.1. My problems are :

The trigger must be pushed quite hard to release the hammer. I remembered when I used marui frame, only a slight push on the trigger would release the hammer.

on some rare occurence, because of this "hard trigger push" the hammer would go into half decock mode.

When I tighten the screw on the blowback housing, the slide would stuck. So What I did was untighten the screw until a certain point where its not tight enough and the cycling would go smoothly. Is this OK to do?

My gun was chronoed 276-280 FPS using guarder gas and .2 bb. Is this
normal?

Gas usage was quite high, I could only shoot 20 bbs using hi capa 4.3 mag

Thats all guys, Any help would be appreciated. Thanks

November 7th, 2008, 07:14	#1
ichimaru gin Trader rating Join Date: Sep 2008	problem : Hi capa with upgraded slide and frame Guys, I just installed shooters design metal slide and frame into my hi capa 5.1. My problems are : The trigger must be pushed quite hard to release the hammer. I remembered when I used marui frame, only a slight push on the trigger would release the hammer. on some rare occurence, because of this "hard trigger push" the hammer would go into half decock mode. When I tighten the screw on the blowback housing, the slide would stuck. So What I did was untighten the screw until a certain point where its not tight enough and the cycling would go smoothly. Is this OK to do? My gun was chronoed 276-280 FPS using guarder gas and .2 bb. Is this normal? Gas usage was quite high, I could only shoot 20 bbs using hi capa 4.3 mag Thats all guys, Any help would be appreciated. Thanks Last edited by ichimaru gin; November 9th, 2008 at 21:13..