UPDATE..
Sorry for lack of coms people. Damn contracts taken up my time solidly for a couple of weeks.... however.. The kaching from it gives me a slight bit of room for more spending
Anyway. I was thinking about the gun stock (origionally planned to fabricate one entirly from metal and bolt it on to the Crain stock tube. Someone pointed out previosuly that the G&P M16 stock can take a 12V battery with no modifications so i just ordered one... I also have the full intensin of cuting it up to alow for expanding on it as a base part
Muhahha
Nearly went el-cheapo because of cuttin git up but i figure this ones probably more robust than a d-boys special.
Now i'm unsure if i will stay with Ni-Mh as previously thoguht. I've started looking in to the sealed unit Li-po's. Still undecided on this really. Any more thoguhts? I think i am also changing the idea of separate battery feeds and going down the individual voltage selection route (resistor) style maybe to reduce wiring and battery damnage. I was toying with the idea also of battery customising. As in not deans or Tamiya. Maybe looking at slot in sockets so the actuall battery pack could be a push and slot in for easy removal with out having to faff about with wires and such inside the stock.
Any thoughts here?
Sooo.. the beasty Flash Hider. I think it wil lbe too long (need a short length but wide in diameter) what i want so i may slice it in half and emove the blackpaint, ploish it up and seal it with laquer/varnish or soemthing like this so it stays a mirror finish silver.
Some posts and ideas/comments suggests would be cool. Threads heading for 10k views already!
Take it easy all!