Quote:
Originally Posted by CDN_Stalker
Jesus Christ of Latter Day Saints!?! A 190 spring and looking for a high rate of fire.......... with a V2 gun? I have a 170 spring for my CA M24 and it clocks at around 540-500fps, but a 190!??! LOL, brutal!!!
BTW, the 16 gauge "low resistance" wiring doesn't do shit, just make sure you install Deans Ultra plugs to replace all the connectors and that'll give you a lot lower of a reistance drop than the wiring will. Stuff found in TM mechboxes is #18AWG teflon insulated wire, similar but not quite the same as mil-spec aviation grade wire. The difference between #18AWG and #16AWG is roughly 1ohm............... per 1000ft. What the #16AWG stuff you are looking to use will give you, is increased current handling ability, which you'd want in such an insane idea like the one you have. 
Good luck with it all! |
BTW I had on my list a
PDI 190% which is about 440fps after the short stroking of the piston. If I were talking about an M190 you would be spot on. I have a PDI 260% in my M16 and its at 496fps.