Airsoft Canada - View Single Post - PTW: convert from burst to auto and vice versa

mcguyver · September 22nd, 2007, 01:18

And the best part is, you can do this without any disassembly to the gun. You can pull out the main circuit board (the one you see when you split open the receivers) simply by pulling straight up on it. You can see the P1 contact points at the bottom of the larger board and can solder them without diconnecting the boards from the gun in a couple of seconds. Just make sure that the battery is disconnected before you do this.

September 22nd, 2007, 01:18	#4
mcguyver Trader rating Join Date: Aug 2005 Location: Northern Alberta	And the best part is, you can do this without any disassembly to the gun. You can pull out the main circuit board (the one you see when you split open the receivers) simply by pulling straight up on it. You can see the P1 contact points at the bottom of the larger board and can solder them without diconnecting the boards from the gun in a couple of seconds. Just make sure that the battery is disconnected before you do this. __________________ Age verifier Northern Alberta Democracy is two wolves and a sheep discussing what's for dinner. Freedom is the wolves limping away while the sheep reloads. Never confuse freedom with democracy. Last edited by mcguyver; September 22nd, 2007 at 01:42..