Airsoft Canada - View Single Post

SBranson23 · May 1st, 2007, 03:52

I think I will go for the 490 motor as I also plan to swap out my zinc gears for the hardened steel ones (which I already have but am afraid to install) and thus be relatively the same as a max version.
I just can't decide which version to get. I will likely never run the M150 spring except possibly one game in Kelowna in the summer. Also I run a Lipo that is only 1320mAh so it may be wiser to pick "B" and it's not like I need a higher rate of fire. My mags can barely keep up as it is.

I ordered a bunch of o-rings (nitrile and viton to compare) from WA based on the metric 2x7mm size suggested. Wallace doesn't know the sizes but stocks them so I will get a couple sets from him too. Looks like this is a part to have around.

BTW, are those RS CASV's or KA copies? (...is it just that the writing is on the other side?)

May 1st, 2007, 03:52	#28
SBranson23 Trader rating Join Date: Jun 2006 Location: Victoria,B.C.	I think I will go for the 490 motor as I also plan to swap out my zinc gears for the hardened steel ones (which I already have but am afraid to install) and thus be relatively the same as a max version. I just can't decide which version to get. I will likely never run the M150 spring except possibly one game in Kelowna in the summer. Also I run a Lipo that is only 1320mAh so it may be wiser to pick "B" and it's not like I need a higher rate of fire. My mags can barely keep up as it is. I ordered a bunch of o-rings (nitrile and viton to compare) from WA based on the metric 2x7mm size suggested. Wallace doesn't know the sizes but stocks them so I will get a couple sets from him too. Looks like this is a part to have around. BTW, are those RS CASV's or KA copies? (...is it just that the writing is on the other side?) Last edited by SBranson23; May 1st, 2007 at 03:55..