use a screwdriver small enough to fit into the spring guide and put that into the end
of the spring. Now as you put the spring into the gun hold down the middle section
with your other hand so it doesnt eject back out. You will have to keep your hand
there till you put the other half of the mechbox on.
Note:
dont even bother putting the spring in till you have everything else ready. I.E. the
gear that pushes on the tappett plate is moved back so no pressure is on the gear,
the trigger assembly is all put back together, All the gears have the shimms and
bearings on them (not on the mecbox as they tend to fall out when putting the
mechbox back together), make sure the cylinder port is near the back of the gun.
Now you can put the spring in and well HAVE FUN!
Oh and be careful, those spring guides can shoot father than your gun sometimes!!! :-D
__________________
No Comment.
|