Airsoft Canada - View Single Post

Oddjob · June 24th, 2006, 18:43

I am having problems with myr M203 slide getting jammed up. There is a long steel square bar that sticks out from the barrel assembly part,

and it hits a steel tab that is apart of the push release that I am having troubles with. It hangs down maybe an 1/8th and gets caught up on the steel tab during use. If I hold the barrel tight against the upper part of the m203 there are no problems, but if it hangs down a little bit it gets jammed. If I use some muscle when closing the barrel it gets jammed real bad.

I am trying to figure out how to go about fixing it. Replace the two spring rolled pins with something a little tighter, or a dowel, or some slightly over sized hardened drill rod?

Has anyone else had a problem like this, and can sugest the best long term fix before I go ahead and start pulling the pins out?

Thanks,

June 24th, 2006, 18:43	#1
Oddjob Trader rating Join Date: Feb 2003 Location: Oshawa, On	G&P M203 Problems w/ pics I am having problems with myr M203 slide getting jammed up. There is a long steel square bar that sticks out from the barrel assembly part, and it hits a steel tab that is apart of the push release that I am having troubles with. It hangs down maybe an 1/8th and gets caught up on the steel tab during use. If I hold the barrel tight against the upper part of the m203 there are no problems, but if it hangs down a little bit it gets jammed. If I use some muscle when closing the barrel it gets jammed real bad. I am trying to figure out how to go about fixing it. Replace the two spring rolled pins with something a little tighter, or a dowel, or some slightly over sized hardened drill rod? Has anyone else had a problem like this, and can sugest the best long term fix before I go ahead and start pulling the pins out? Thanks,