|
Okay new update on my quest for motorization. For anyone who is an electric motor guru I need a hand. I have a 3 cm long electic motor (shown in picture) with a 2mm diameter shaft with a lenth of 6mm. The pinion in the picture is part of my high cap mag and is 13mm in length. In order to motorize the magazine I need a motor of the same specs that is front loading with a shaft of 18mm (outside of the motor) to go directly into the high cap housing and replace the pinion. Easier said than done. I am gona hit some electric motor shops but from phoning around its gona be a pain in the buttocks. I am gona be running it at 4.8v so just a generic motor would do the trick. Does anyone know of a place that carrys custom/odd ball small electric motors around the lower-mainland? if so add me to msn and or contact me.
Peace!
|