[crazyninjadude]

So, I just bought a used version 1 KJW 10/22. When I went to disassemble it to replace the 6.01 RA tech TBB that it came with, with the stock barrel, I found out that the inner and outer barrel seem to be stuck together somehow. After reassembling it and taking it out for some long range shots to get the scope sighted in, I found that it is curving significantly to the right. After disassembling it, cleaning the barrel, and making sure the hop up unit is aligned it is still curbing right at about 100' or so (and curves to varying degrees of hop). No amount of fiddling with it that I've done over the past week has managed to resolve this. Hopefully, someone here would be able to mention some solutions that have worked for them, or at least be able to point me in the direction of some airsoft techs (reasonably) near the Ottawa Valley, as I am just new to the airsoft scene in Ottawa (I'm usually in Alberta during the university semesters)

Thanks,

Chioke