Airsoft Canada - View Single Post

br0k3nsa1nt · February 25th, 2016, 00:41

Ok ladies and gents, I figure I may have a faulty unit on my hands but I want a second opinion.

I recently installed the Gate Merf 3.2, running wires directly from the motor to the unit and running the dual signal wires to the trigger contacts.

I have:
Verified my polarity
Hooked the battery directly to the motor(out of the gearbox)
Used the trigger to program the mosfet.
Saved, disconnected, reconnected.

When I try to fire it goes back into programming mode, telling me it's not seeing the motor.

My only other thought is that my LiPo, which has been in storage, has too low of a voltage and the mosfet is not allowing it to fire?

Sent from my iPhone using Tapatalk

February 25th, 2016, 00:41	#1
br0k3nsa1nt Trader rating Join Date: May 2010 Location: London, Ontario	Gate Merf 3.2 Ok ladies and gents, I figure I may have a faulty unit on my hands but I want a second opinion. I recently installed the Gate Merf 3.2, running wires directly from the motor to the unit and running the dual signal wires to the trigger contacts. I have: Verified my polarity Hooked the battery directly to the motor(out of the gearbox) Used the trigger to program the mosfet. Saved, disconnected, reconnected. When I try to fire it goes back into programming mode, telling me it's not seeing the motor. My only other thought is that my LiPo, which has been in storage, has too low of a voltage and the mosfet is not allowing it to fire? Sent from my iPhone using Tapatalk __________________ If it moves, kill it. If it doesn't move, kill it now, It might move later.