Quote:
Originally Posted by ThunderCactus
When you assemble the mechbox and you push on the nozzle, does it move back and forth freely, or does it get stuck?
Could be the sector gear is pinching it
|
Moves freely with out snags.
Quote:
Originally Posted by lurkingknight
did you change anything recently on your rebuild?
If you changed out tappet plate, hop up rubber or nozzle, you'll need to look at those parts a little more closely.
Compare the nozzles side by side if you replaced it but don't have calipers to measure. As little as a tenth of a mm is enough to fuck it up. Are the profiles of the nozzle tip the same? are they both beveled at the same angle?
|
Tappet and nozzle were changes to brand new versions of the same parts that were previously installed. Always order spares to keep on hand.
Nozzles appear identical as far as tip profile.
I have the delat clip and some more nozzles on the way. Should be in before the weekend. Will update.