Quote:
Originally Posted by Sequential
+1 Azimuth is shit. Azimuth makes so much bad products, I don't even understand how they are still producing stuff. Even the loading nozzle from them kept getting stuck with my enhanced cylinder.
|
The one in my MP5k kept getting stuck, and because I didn't notice it for a while the little retaining tabs at the end of the bolt head almost wore through the bottom guide rail on the nozzle
Sanded the nozzle itself down to move more smoothly and the enhanced cylinder and the wear has stopped, lucky though if I hadn't noticed it it could have worn through completely and then I would have been pissed!!
I thought about the V2 to replace it anyway but I've got about 3 spares so not bothering until I run short.
For lowering the FPS I've used the Azimuth power reduction valve from WGC, alongside the standard nozzle, that didn't quite do the job for what I needed but I had the weaker springs left over from the alloy bulb I used in the K, dropped the weakest one in and, it's now well under my requirements.
I've also been told by a Umarex rep that another good way of doing it on the cheap is to fill out the hole in the original cylinder bulb with some form of plastic, he suggested a small piece of unjamming rod and simply drill it out 1mm to start and then a further 1mm after every chrono test until you get the required FPS.