Airsoft Canada - View Single Post

pestobanana · July 10th, 2013, 03:13

Is it normal for Lonex motors to burn through brushes really quickly? I've only had my A1 for a week and I've changed the brushes three times already. Every time the motor spins I see residue blowing off the brushes.

What keeps happening is due to poor connection, every other trigger pull my MERF 3.2 will enter programming mode, as it doesn't detect the motor being connected. Then I have to reset the MERF and the same thing happens again. If I change the brushes, the motor is set for another two hundred shots or so... Then the same thing happens again.

RoF has also dropped since the motor was new, I used to get 31 RPS and now it's dropped to 23-25 on a full charge, using a 11.1V 25C Li-Po.

July 10th, 2013, 03:13	#1
pestobanana Squid Porn Superstar, I love the tentacles! Trader rating Join Date: Nov 2008 Location: Richmond Hill and Waterloo, Ontario	Lonex Motor Brushes Is it normal for Lonex motors to burn through brushes really quickly? I've only had my A1 for a week and I've changed the brushes three times already. Every time the motor spins I see residue blowing off the brushes. What keeps happening is due to poor connection, every other trigger pull my MERF 3.2 will enter programming mode, as it doesn't detect the motor being connected. Then I have to reset the MERF and the same thing happens again. If I change the brushes, the motor is set for another two hundred shots or so... Then the same thing happens again. RoF has also dropped since the motor was new, I used to get 31 RPS and now it's dropped to 23-25 on a full charge, using a 11.1V 25C Li-Po.