Airsoft Canada - View Single Post

Nova316 · April 30th, 2013, 11:13

Whoa, first bad review I've read from the others saying FCC 416D are good. The FCC HK416D body I found to be quite good compared to the other ones I've seen. The Moe grip does have the end cap and I am sure you could message FCC and replace it with an Tango down grip as they have great customer service. I've assembled and looked at quite a few of these HK416 and didn't see much wobble in them, so having wobble is not common at all. Also quite strange that you'd be expercing so many problem.

I've seen quite a huge change switch from the PTW/Tack motor to the FCC motor, and a bit more when I switched over to the FCC gearbox.

For there outer barrel, I was able to install this into PTW bodies, I've done a few. Never tried Real Steel upper tho so I cannot comment on that.

When you get a new sun gear make sure you get a new bevel gear as well, since the ratios are different they are different size. The pigtail took a while to get use to when installing into the body but its suppose to help the wire bend into the optics board without getting pinched.

Sucks you are having such a negative experience with FCC products as I've used quite a few from parts from FCC and haven't faced what you have.

April 30th, 2013, 11:13	#169
Nova316 Trader rating Join Date: Nov 2006 Location: Calgary	Whoa, first bad review I've read from the others saying FCC 416D are good. The FCC HK416D body I found to be quite good compared to the other ones I've seen. The Moe grip does have the end cap and I am sure you could message FCC and replace it with an Tango down grip as they have great customer service. I've assembled and looked at quite a few of these HK416 and didn't see much wobble in them, so having wobble is not common at all. Also quite strange that you'd be expercing so many problem. I've seen quite a huge change switch from the PTW/Tack motor to the FCC motor, and a bit more when I switched over to the FCC gearbox. For there outer barrel, I was able to install this into PTW bodies, I've done a few. Never tried Real Steel upper tho so I cannot comment on that. When you get a new sun gear make sure you get a new bevel gear as well, since the ratios are different they are different size. The pigtail took a while to get use to when installing into the body but its suppose to help the wire bend into the optics board without getting pinched. Sucks you are having such a negative experience with FCC products as I've used quite a few from parts from FCC and haven't faced what you have. Last edited by Nova316; April 30th, 2013 at 11:22..