Quote:
Originally Posted by Hectic
Okay so in my quest to become a wetard i think i have a list
NPAS
Tight bore (havent picked one yet)
Hop rubber (also havent picked one yet)
If i can find one spare nozzle but ill likely just wait till the stock one breaks then swap in the ratech aluminium one.
Now for some new questions.
Co2 or propane?
I know co2 should be more consistant and work in colder temps and such but is it alot harder on internals or about the same at a given fps?
Are the mags better or worse then the green gas mags as car as leaking and durability?
|
I've gotten extremely good results out of the Angry Gun 380mm 6.03mm barrel for the G39, but I have a 16 inch barrel. Your best bet, if you REALLY want something nice, is a VSR barrel (PDI or EDGI), but that requires slight modification to your hopup chamber and you may have to cut down a barrel or two.
I use a Modify rubber in my rifle, and right now I can shoot out to 60 feet at 7.5 MOA under perfect conditions. Nowhere near what a bolt action can do, but good enough considering the advantages of a GBBR. Shimming the inner inside of the outer is the best thing for accuracy I've done so far.
Rarely ever needed to change out a nozzle. If anything I've learned two things: Don't ride the charging handle, and never Tap Rack Bang- Always run a Double Feed Drill if your rifle stops firing.
The Generation 2s are amazing in terms of durability. I was at UA, magazine ran empty in a very bad situation. Dropped it four feet onto concrete while reloading. Picked it up, it's a little dinged up, but still running like a champ.
I'm pretty sure my rifle is 80% RS at the moment... that's preference though. Run it, see what makes you happy, and go from there. The only thing I suggest is you shim the bolt catch and purchase a RS magazine detent ($3), that will remove any bolt locking problems you'll ever have. The FA doesn't work all the time, the RS one does. You don't need an FA on this rifle though... then again it did come in useful when I rode the handle forward on a very, very dirty and dry gun. Turns out that, and the steel bolt's lack of proper dimensioning were causing the Bolt Carrier not to seat fully, resulting in me venting a magazine when I fired it.