Quote:
Originally Posted by RacingManiac
Anywhere you can get replacement foam piece for these? Trying to form the foam piece with the pre-cut little square for a pistol and it went horribly....:P
|
The supplied pluck foam is a joke. There are full (and not half-pluckable) cuts going across diagonally, so remove a single piece of foam and the entire thing will split into two. Who seriously designed this stuff? Rofl.
Quote:
Originally Posted by BloodSport
That effect can be cause in shipping even with not visible damage to the packaging, if there is heavier items stacked on top of it causing it to flex while in transport, considering that the length of the cases is metal and if it gets slightly warped due to this it will cause the wobble your experiencing. Neither of my cases had any issues, they were shipped together in one massive box, the guy who delivered it did it with a dolly because of the weight, inside the large box each case was individually wrapped inside 4 other boxes each, so no chances of physical damage. If you only received 1 case each time though, your warp could have been done in transit.
|
Perhaps, but I still think the problem lies within Mezzi's QC.
Keep in mind my broken black aluminum case didn't have the "coffee table effect" (but had all those frame dents which would have shown on the shipping box if it was caused by UPS), while the ABS ones I received all had the exact same wobble. It's not a big issue though so I'm more than satisfied with my purchase.