Quote:
Originally Posted by jordan7831
Are you talking about the plunger in the slide that the nozzle return spring rids on.
|
Yes.
Its the piece that sits behind the extractor. The piece that you put into the spring before you put the spring back inside. You need to mod the part where the pring attaches to. That end. sand it shorter.
It looks like a detent pin, Jordan. Like the ones found on the hi capa/1911 that locks the thumb saftey to prevent accidental activation
__________________
"May you fight with the strength of ten full grown men."
Last edited by e-luder; February 1st, 2013 at 21:03..
|