Airsoft Canada - View Single Post

K3vX · January 26th, 2013, 23:41

I think Gate usually provides a guide on how to use their products. Look online for documentation.
http://www.gatee.eu/picossr_en.pdf

Ohh, you meant the little wire. I'd suggest applying a bit of solder on the contact first, then while holding the cable melt it again, and ''dip'' the exposed wire end in the hot solder. Should hold, and be clean. Be sure to be quick, or the heat transfer will melt the insulation in the cable.

January 26th, 2013, 23:41	#3
K3vX Trader rating Join Date: May 2012 Location: Quebec City	I think Gate usually provides a guide on how to use their products. Look online for documentation. http://www.gatee.eu/picossr_en.pdf Ohh, you meant the little wire. I'd suggest applying a bit of solder on the contact first, then while holding the cable melt it again, and ''dip'' the exposed wire end in the hot solder. Should hold, and be clean. Be sure to be quick, or the heat transfer will melt the insulation in the cable. Last edited by K3vX; January 26th, 2013 at 23:45..