Quote:
Originally Posted by Kokanee
Quite well actually. I started to get some stoppages when firing with the bolt carrier partially forward; immediate action of pulling the bolt handle back and letting it fly would then result in a slam fire. Turns out the pin that was used to hold the rear sight base onto the barrel was slightly too small in diameter and the sight base started to wobble , causing friction and not allowing the bolt carrier to travel all the way forward.
Fixed this by boring out the hole in the sight base and installing a real AKM pin which was larger, did the trick. Other than that no problems whatsoever... The mags could be easier to maintain as I have had a few pop seals, winter project is to sit down, strip them down to parts, soak in oil a few days and reassemble and they should be fine.
|
Are the leaks on the shaft of the striking part of the valve,that is where mine
is leaking on the first GHK they made. The silver shaft has two orings,but the
brass cylinder it rides in is rough.
