Quote:
Originally Posted by turok_t
The G18C's trigger/hammer set was perfect. Complete drop in and no difficulties/modding needed for the valve knocker..
For the AIP G17 bearing, did you grease up the outside of the bearing or did you use bearing oils for the balls in the bearing?
|
i had to use oil based lubricants to get inside. the grease that i was using was a bit thick and caused a little friction when the bearing spun. put it a small amount in an eye dropper and off it went.
although i agree with you. that aip bearing is bigger than it needs to. i replaced it with an 8mm bearing to avoid future damage.