Airsoft Canada - View Single Post

Neurotrauma · October 17th, 2011, 23:46

I tested it once, with the fuse removed and the two halves connected, just one shot on semi to test the motor with it outside the handgrip, and it is still functionning. The polarity is correct, could I be putting the motor in the wrong way?

could it still be a short if its working with no fuse?

I dont think I moved anything with the shims??? only the first gear and the anti reversal latch came off and i put them back on as the video directed...

EDIT:
Okay so I've looked up shimming and it appears that I may have take two of the little washers thinking they were part of the trigger assembly and I put them as washers on that, I have no knowledge about shimming or anything so I guess its back to the research table, the other gears never fell out so Im not sure exactly where this came from.

October 17th, 2011, 23:46	#5
Neurotrauma Trader rating Join Date: May 2011	I tested it once, with the fuse removed and the two halves connected, just one shot on semi to test the motor with it outside the handgrip, and it is still functionning. The polarity is correct, could I be putting the motor in the wrong way? could it still be a short if its working with no fuse? I dont think I moved anything with the shims??? only the first gear and the anti reversal latch came off and i put them back on as the video directed... EDIT: Okay so I've looked up shimming and it appears that I may have take two of the little washers thinking they were part of the trigger assembly and I put them as washers on that, I have no knowledge about shimming or anything so I guess its back to the research table, the other gears never fell out so Im not sure exactly where this came from. Last edited by Neurotrauma; October 17th, 2011 at 23:51..