i have a problem lately that involved th SD nozzle inside an upgraded hi capa, the picture below show my old nozzle that suddently refuse to load BB's (still cycle normally, though rather weak) and fps is 360 (0,2 BB with bb manually put inside the chamber). when i cycle the gun with my hand slowly, i can see that the "pin" that suppose to push the BB forward is slipping above the BB. after i remove the nozzle, i noticed that it is kinda bend upward, and there's a hole on the side where some "rail" used to be.
the thing is, after i replace the nozzle with a new one (the one above), it still wont chamber BB correctly AND it breaks and have the exact same hole just after 1 magz of tries.
what have caused this? i use guarder power up gas which shoots kinda hard but i think its just straight up propane. i dont think it is caused by the pressure being to hard.
this also happens with my first nozzle AFTER i tried using long hi cap (50bb) magz. i dont know whether this is a coincidence or not, but my friend's hi capa with SD nozzle also cannot chamber BB from his long mag (50bb), but his nozzle is not broken and still able to chamber BB from normal magz just fine.
this is the picture i'm talking about
anyone have experienced similar case?
i already buy another nozzle (AS this time) but are afraid that something else in my gun is causing this and that my AS nozzle will be broken as well.
thanks