Quote:
Originally Posted by RacingManiac
40 round...not 400..lol
But yeah, I was kinda surprised since knowing how shitty 1911 does with a metal kit.
|
LOL, my bad. Wishful thinking there...
Quote:
Originally Posted by jamuke
get a tb inner barrel..I happily used my glock for CAPS with very good accuracy( I had a PDI)
I would advise against an enhanced trigger spring, I had 2 pistons snap at the back (like the blow back unit in the hi capa) and these are NOT easy to find. neither is a stock non enhanced trigger spring( though I ran across a site rcently that had them for $5, of course I forget the site)
I found for slide and barrel that the gaurder tolerances were a little loose in the slide fit on the frame rails and outer barrel/slide fit could have been tighter
My PGC was nice and they are not that expensive
I also had the upgraded mag catch and trigger bar etc on one glock, the other stock one did not seem to suffer any from being stock.
however with the new mag catch it takes a bit for the part to wear in, occasionally the mag would not just drop out..a little gun movement would do to drop it ..eventually this will stop happening
|
I try to avoid TB's if possible... Might be worth it for the Glock as the stock muzzle velocity seems to be lower than I had hoped for on propane.
Not quite sure what a "trigger spring" is... something like a hammer spring or what? Or is it a trigger spring from a spring kit - I was thinking of getting one of those as I've been very happy with the 3 I've had and used so far.
Yeah... screw Guarder. Will go PGC when the time comes that I finally decided that I'm going to get a metal slide/barrel combination for my Glock. Any further thoughts on this?
What mag catch did you get?