|
(not a response to Slono's post)
If I'm going to go ahead and replace my cloned MEU's hammer/sear/valve knocker/strut anyway (yes aftermarket bits will fit), should I go ahead and order a disconnector for my single-stacker while I'm at it?
I ask because I've noticed that the clone internals are not built out of great metals, and would be interested to know in advance if the contact between the sear and disconnector would be a potential point for rapid wear/break down.
Just a note, an aftermarket leaf spring and stirrup are also on my list of parts to buy - I'm thinking that a good disconnector-stirrup fit (i.e. parts from the same manufacturer) would make for a better trigger response, am I correct?
|