Airsoft Canada - View Single Post - FAQ for Tokyo Marui Hi-Capa, 2011, 1911, MEU & Detonics type variants

Slono · January 6th, 2010, 19:30

Okay.

If you look at the picture I have with the NOVA rear sight in it, you'll notie that it has the two main notches that slide into the slots on the slide, and then a square one that is there to only allow the slide to slide in one way, and up to a certain point. I can remove the other piece of aluminum below that pushes on the BBU, but I don't want to remove the square piece...

I'm going to try sanding the BBU. I was a dumbfÜck for thinking I could do this with almost zero experience. But I don't regret it =)

January 6th, 2010, 19:30	#84
Slono Slow mo. Trader rating Join Date: Aug 2009 Location: GTA	Okay. If you look at the picture I have with the NOVA rear sight in it, you'll notie that it has the two main notches that slide into the slots on the slide, and then a square one that is there to only allow the slide to slide in one way, and up to a certain point. I can remove the other piece of aluminum below that pushes on the BBU, but I don't want to remove the square piece... I'm going to try sanding the BBU. I was a dumbfÜck for thinking I could do this with almost zero experience. But I don't regret it =) __________________ The ultimate measure of a man is not where he stands in moments of comfort and convenience, but where he stands at times of challenge and controversy. - Martin Luther King, Jr. Last edited by Slono; January 6th, 2010 at 19:33..