Spring broke
Hello. I have a classic army m15a4. My setup is:
G&P m160 Motor
Elite 12v mini battery wired to deans
G&G hyper torque helical gears
CA tightbore with Systema Hopup bucking
Guarder SP140
Most of these parts i got at the same time, and when installed, gave great fps. Then it started dropping to an unhealthly level, so i called the place (airsoftgi.com) where i bought the parts with the question of did i have a defective spring or were my airseals bad. I was told the latter. I did not have the money to buy new airseal parts yet so i left it how it was and dealt with the low (but still better than stock) FPS. Well a month later the spring snapped in 2 toward the back of the spring right where the coils start to get tight. I then called them again and asked for a new spring because I figure that it was defective; a spring shouldn't just "snap". Everything ran very smoothly, i just had a decrease in fps and then a eventual snap. Do you guys agree? Shouldn't i get a new one? I am in the middle of disputing this with them via email.
Thank you for your time.
-Brett
__________________
Last edited by incrediboy729; September 23rd, 2009 at 13:21..
|