Airsoft Canada - Plz help ID where this piece goes on Umarex G36CV?

Airsoft Canada (https://airsoftcanada.com/forums.php)

- Doctor's Corner (https://airsoftcanada.com/forumdisplay.php?f=18)

- - Plz help ID where this piece goes on Umarex G36CV? (https://airsoftcanada.com/showthread.php?t=182443)

Plz help ID where this piece goes on Umarex G36CV?

Hey Guys,

So on my first time opening up a v3 gearbox on a Umarex G36CV, i find this piece that I just cant figure out where it goes. Looked everywhere online but cant find a good instruction.

Could someone here with experience tell me where should I install this piece? At which step of the assembly sequence (i.e. before closing gearbox, after closing gearbox etc.)

I'm fairly familiar with v2, but just my first time round with a v3.

Thanks in advance!

Quote:

Originally Posted by ao_tenshi (Post 2001009)

G36 is rear wired. That piece is a wire retainer that goes in the back side (towards the stock) in a large hole. It helps your wiring from getting caught on the lower and upper receiver.

That piece goes in AFTER you've closed the gearbox.

From the motor cage, run your wiring up the left or right side (I can't remember/ and insert that unidentified piece the large hole about 2-5 cm below the spring guide and secure the wire to the gearbox.

It's the transparent bit that is shown here:

http://pb-images.voraciocommerce.com...pg?auto=format

Really appreciate your response RainyEyes!!! I was looking everywhere and cant figure out where this fell out of.

it doesn't neeed to be there so if it was left out it's no big deal.