Flash Hider
 

Anyone know what the tap and dai size is on a 14mm flash hider?
Yes I know it is a 14mm cw or ccw thread but is it a m14 x 1 or a m14 x 1.5 or a m14 x 2? I need to retap one of my flash hiders.

Thankx

This does not answer your question, it is, however, a possible cheaper solution:

Assuming the flash hider is aluminum and the threads aren't too gnarly, you could carefully thread it onto a steel outer barrel in an attempt to re-cut the flash hider's threads.

Best suggestion would be to go buy a set of Taps & Dyes at your local CT. They normally come with a metal gauge combs.

14x1.0

Thankx all... 14x1.0 FTW