KWA Glock 18c Problem
 

Ok Everytime I put Bb's in the mag then put it in the gun then cock it back and press the slide release the BB doesn't load inside the chamber at all. It stays stuck in the slide and i always have to disassemble the gun to take the bb out.Some times I could just take out the mag and wobble it alittle and the bb will just fall out.

So basically the BB won't load in the chamber at all.

Any suggestion whats wrong with it?

Maybe you should've posted this on the "Doctor's Corner" section. Hope you'll find an answer to your question.

could i dont know be BROKEN

Yeah, but that doesn't mean it can't be fixed.

Sounds like the little arm under the nozzle is broken. That's what is supposed to push the bb out of the mag and into the chamber.

So where can I buy a new loading nozzle? Because I checked a ton of websites and they were all out of stock

Did you have a look and figure out that was indeed the problem?

Check part 22 for damage. If I'm not mistaken, KSC Glocks 17 and 18c share the same part 22, so looking for a Glock 17 loading nuzzle might be easier.

http://unconventional-airsoft.com/gf...kpartslist.gif

Yes I checked it and it seems like a small part of it was chipped off in front of it

sʎnƃ ıɥ