Will the VLTORR hold a battery?
 

I'm looking at this stock. and wondering what sort of battery can be stuck in there?

It only mentions AA etc.

http://www.ebairsoft.com/vltorr-enha...ack-p-994.html

Shawn

66Bear on this forum has this stock slightly modded it will hold a 9,6 nunchuck or triple Crane battery

Excellent thank you.

Already ordered one :)

I've got that stock. I run a KA lipo stock and lipo buffer tube. It's awesome. If you've got any questions PM me. I'll tell you all about it.

Same setup as mine, very nice setup over all. Sometimes the wires don't want to fit in with the battery without a few minutes of dicking about with it.

were you able to find a way to put in a lipo alarm? or do you find you dont game long enough in a single day to really worry about it?

I don't find that with that battery that I use I don't have a problem with it getting low. In fact with any lipo battery I've used I've never had a problem with them running down.

The tubes should fit 2/3A batteries. May need to cut a channel for the wire.

http://www.arniesairsoft.co.uk/forum...ic=131620&st=0

I've been through two games on the one lipo and it still doesn't need charging. No real point trying to get a lipo alarm in there unless you are really paranoid.

But, if you do decide to go the Lipo way, i'd suggest to pick up that little chip you can plug into the batteries balancer plug to check the voltage of each cell and total voltage in the battery.

yeah I plan to get one.

Really I dont run through enough ammo to ever kill a lipo in a single game. so I'm not too concerned.

A buffer lipo may work. I would have done that with my magpul CTR stock. But I have a TM in there already. heh.

Should have it next week. Will see what I can do than. I still havnt purchased a buffer tube yet.