we hi capa see post on page 2 please
 

... man I need to stop owning gas anything lol.

Ok I had a broken loading nozzle on my we hi capa so I replaced it with a matrix loading nozzle. while I was in there I noticed the hop up was really oddly positioned, took it out and it was really super soft. So I have replaced it.

Now with the new loading nozzle in and the hop up installed when I go to fire the gun and it just vents the whole mag. The slide barely moves back.

Where should I be looking to fix this? the disconnect is working *I push down on it and it pulls the knocker back in, i think the issue is the slide is not coming back to hit the nub so it just keeps venting gas.*

Did you remember to put the internals of the old loading nozzle into the new matrix one?

umm... this is why working on guns after 36 hours of being awake is not a good idea... your right *facepalm*


how does this go in I took it apart and didn't think to look at how it came out.

alright I got it to cycle. But the BB is not firing out it just kind of dribbles out of the barrel. hop up is completely off.

Does the internals of the loading muzzle go Spring, nozzle, retainer?

Are you missing a screw that goes through top of loading muzzle into hole in "retainer" (valve blocker)?

nope thats in there. thinking maybe the air chamber needs to break in or something. Should I try a few drops of oil to get BB's moving through it?

Its a WE? Well theres your problem!

helpful.

Don't do that, whatever you do. You said your hop up is off right? Turn it on and see what happens. Sounds to me like the hop up rubber isn't retaining BB's correctly... Try chambering a round and then pointing the muzzle at the floor. If a BB rolls out because of gravity, well that'd be the issue of not having any hop up set.

no the BB doesn't roll out, it sits right in the area of the hop up... its like not enough gas is being used during the firing process of the shot.

Well like someOne said it's a WE.
If you can't get it to work bring it by my place with all the stock peace's and leave it with me and ill see if I can fix it for you.

i may just do that, either you or ktown. I went to test fire it the other day and the fill valve was leaking so its soaking in silli oil right now.

So the gun cycles but no BB comes out? Then perhaps the rocket valve is stuck in the forward position?

Is it a white nozzle? The valves in those get stuck, use the stock valve

no its a matrix loading muzzle....

do I have this right?