yeah it would have slightly less resistance and reliability...

Get someone to properly solder your wires.

for now i will twist the wires. but until really the summer stats i wont be using this gun. just a little plinking here and there so by outdoor season i will definatly have someone take a look at it and try to solder it.
thanks.

Talked to my dad and apparently we do have a solder lol so i will be doing that shortly after watching some videos to make sure i do it properly.

if you have soldering paste be sure to apply a small amount to the wires... it will make the operation much easier

take some spare wires. cut 2 pieces and strip about half an inch on both so you can practice. also get a bit of heat shrink.

ok so watched a couple how to videos and talked to my dad and tried it out. pulled the trigger on the gun....shit it doesnt work...o w8 i have to put a battering in first...YAY it works lol and then i put some electric tape on tightly so it should be good..thanks guys.

Make sure you are using Electrical Tape.
Also you can always go to Canadian Tire and purchase some of these fuse holder. They are cheap and they are easy to use. All you do is snap the fuse in and out
http://img.photobucket.com/albums/v2...n/IMG_2268.jpg